| | Liebert XDR-W Back-of-Rack Cooling Module| The Liebert XDR is a Back-of-Rack Cooling Module which draws hot air from the rack and cooling it to the point where the impact on the room is close to neutral, then discharging it back into the room. Liebert XDR-W cooling modules are attached to the back of your selected racks, drawing hot air from the rack and cooling it to the point where the impact on the room is close to neutral, then discharging it back into the room. These modules are connected to a Liebert XDP-W coolant pumping unit, which acts as an isolating heat exchanger between the building chilled water source and the circulating cooling water. The modular and adaptive design of the Liebert XDR-W unit also allows it to be easily added as the demand for cooling increases. |
Liebert XDR-W Flexibility: - Installs and configures easily
- Allows scalability for future growth.
- Provides flexible configuration to eliminate hot spots.
Liebert XDR-W Higher Availability: - Provides built-in redundancy: A dual pump in the coolant distribution unit will keep the fluid flowing; if a fan in the cooling module shuts down, the others keep running.
- The pumping unit maintains the coolant to the XDW-R at a temperature always above the actual dewpoint, to prevent condensation.
Liebert XDR-W Lowest Total Cost Of Ownership: - Operates with the energy-efficient Liebert XDP-W coolant pumping unit, which can support up to 12 XDR-W modules.
- Saves energy by cooling at the heat source.
Liebert XDR-W is ideally suited for: - Applications where a hot aisle/cold aisle approach is not practical.
|  |
Liebert XDR Installation Diagram
| |
